Bosch Dishwasher E24, Not Draining: A Bone Jammed the Drain Pump
This is a real repair from our work, on a call off Sunset Boulevard in West Hollywood. A Bosch dishwasher finished its cycle with water still sitting in the bottom of the tub, and the display showed E24. On a Bosch, E24 means the dishwasher can't drain.
What E24 usually means
When a Bosch shows E24, we check five things, in this order:
- The air gap on the sink. Many West Hollywood kitchens have a small chrome air gap cap next to the faucet. Food often gets stuck in it, the water can't get out, and the dishwasher reports a drain pump error. Pop the cap off and clear it first — it's the easiest fix.
- The filter at the bottom of the tub is clogged.
- The drain hose under the sink is kinked or blocked.
- The garbage disposal knockout plug was never removed after installation.
- The drain pump is jammed or has failed.
What we found
The air gap, the filter and the drain hose were all clear. The problem was the drain pump: a small bone had gotten past the filter and jammed the pump's impeller, so the pump couldn't spin and the water had nowhere to go.
How the repair went
- Pulled the dishwasher out from under the counter.
- Released the clip that holds the drain pump.
- On this Bosch, the pump comes out with a half turn.
- Removed the bone from the impeller.
At that point you can put the old pump back, and the dishwasher will drain again. But we recommend replacing it with a new pump. A pump that has been running while jammed can overheat, and an overheated pump often fails a few weeks later. That's what we did here: a new drain pump went in, and we ran a full cycle to confirm it drained.
Why the right replacement pump matters
Not all Bosch drain pumps are the same. On the correct pump for this dishwasher, the impeller blades are cut at an angle. Some cheaper replacement pumps look almost identical but have flat, square blades with no angled cut. They move water differently, and after installing one the dishwasher can keep showing the same drain error.
That can make it look like the control board is the problem, when it isn't. The fix is simple: install the pump that matches the model — with the same impeller blade shape as the original. That's what we use.
What it cost
This repair — drain pump replacement — came to $320. The $89 diagnostic is credited toward the repair, and you get the price before any work starts. The repair has a 90-day warranty.
How to avoid it
- Scrape bones, olive pits, seeds and other hard scraps off plates before loading.
- If a glass or dish breaks inside the dishwasher, pick out every piece and check the filter — small shards are a common reason drain pumps jam.
- Load glasses so they can't tip over and hit each other during the cycle.
- Rinse the round filter at the bottom of the tub about once a month.
- If your sink has an air gap next to the faucet, pull off the cap and clean it every few months.
- If you see E24, don't keep restarting cycles — a jammed pump can overheat.